100
Chapter 5
Configure the Router in WISP Mode (Hotspot Mode)
•
Subnet Mask
- The Subnet Mask determines which portion of an IP address is
the network portion, and which portion is the host portion.
•
Gateway
- This is the IP address of the default gateway device that allows the
contact between the router and the network or host.
3. Select
Enabled
or
Disabled
for this entry on the
Status
drop-down list.
4. Click
Save.
5. 11. 2. System Routing Table
1. Visit
http://tplinkwifi.net
, and log in with the username and password you set for the
router.
2. Go to
Advanced Routing
>
System Routing Table
, and you can view all the valid route
entries in use.
•
Destination Network
- The Destination Network is the address of the network or host
to which the static route is assigned.
•
Subnet Mask
- The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
•
Gateway
- This is the IP address of the gateway device that allows for contact between
the Router and the network or host.
•
Interface
- This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN (Internet).
Click
Refresh
to refresh the data displayed.
5. 12. Bandwidth Control
1. Visit
http://tplinkwifi.net
, and log in with the username and password you set for the
router.
2. Go to
Bandwidth Control
.
3. Tick the
Enable Bandwidth Control
checkbox, and configure the
Egress Bandwidth
and
Ingress Bandwidth
, and then click
Save
. The
Egress/Ingress Bandwidth
is the
upload/download speed through the WAN port. The value should be less than
100,000Kbps.
Downloaded from