TP-Link TD-W8961N, Руководство пользователя

Страница: 44 / 85

User Guide
41
4.3.2 Routing
Go to Advanced Setup
→
Routing , and you will see the routing information in the following
screen.
Click ADD ROUTE to add a new route in the following screen.

Destination IP Address: This parameter specifies the IP network address of the final
destination.

IP Subnet Mask: Enter the subnet mask for this destination.

Gateway IP Address: Enter the IP address of the gateway. The gateway is an immediate
neighbor of your ADSL modem router that will forward the packet to the destination. On
the LAN, the gateway must be a modem router on the same segment as your modem
router; over Internet (WAN), the gateway must be the IP address of one of the remote
nodes.

Metric: Metric represents the "cost" of transmission for routing purposes. IP Routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need not to
be precise, but it must between 1 and 15. In practice, 2 or 3 is usually a good number.

Announced in RIP: This parameter determines if the ADSL modem router will include the
route to this remote node in its RIP broadcasts. If set to Yes , the route to this remote node
will be propagated to other hosts through RIP broadcasts. If No , this route is kept private
and is not included in RIP broadcasts.