TP-Link T3700G-28TQ, Руководство пользователя

Страница: 400 / 430

Note:
For detailed introduction of TLV, please refer to IEEE 802.1ab standard.
In TP-Link switch, the following LLDP optional TLVs are supported.
Port Description TLV The Port Description TLV allows network management to
advertise the IEEE 802 LAN station's port description.
System Capabilities TLV The System Capabilities TLV identifies the primary functions of
the system and whether or not these primary functions are
enabled.
System Description TLV The System Description TLV allows network management to
advertise the system's description, which should include the full
name and version identification of the system's hardware type,
software operating system, and networking software.
System Name TLV The System Name TLV allows network management to
advertise the system's assigned name, which should be the
system's fully qualified domain name.
Management Address
TLV
The Management Address TLV identifies an address
associated with the local LLDP agent that may be used to reach
higher entities to assist discovery by network management.
Port VLAN ID TLV The Port VLAN ID TLV allows a VLAN bridge port to advertise
the port's VLAN identifier (PVID) that will be associated with
untagged or priority tagged frames.
Port And Protocol VLAN
ID TLV
The Port And Protocol VLAN ID TLV allows a bridge port to
advertise a port and protocol VLAN ID.
VLAN Name TLV The VLAN Name TLV allows an IEEE 802.1Q-compatible IEEE
802 LAN station to advertise the assigned name of any VLAN
with which it is configured.
Link Aggregation TLV The Link Aggregation TLV indicates whether the link is capable
of being aggregated, whether the link is currently in an
aggregation, and if in an aggregation, the port identification of
the aggregation.
Max Frame Size TLV The Maximum Frame Size TLV indicates the maximum frame
size capability of the implemented MAC and PHY.
The LLDP module is mainly for LLDP function configuration of the switch, including four
submenus:
Basic Config , Device Info, Device Statistics and LLDP-MED .
16.1
Basic Config
LLDP is configured on the Global Config and Port Config pages.
16.1.1
Global Config
On this page you can configure the LLDP parameters of the device globally.
389