Toyota JAT710, Руководство по установке

Страница: 90 / 136

3. PREPARATIONS FOR WEAVING START-UP
90
[ 2 ] Properties of Lubricants
[ 3 ] Lubricants Required Before Trial Run
[ 3.1 ] For negative tappet cam shedding motion
*1
For applying oil A, use the oiler (Tool No. 695) provided with the machine.
*2
No oiling is required for the half-leno selvage device.
*3
The tappet cam box and the tucker housings (if the tuck-in device is selected) are not lubricated when the
machine leaves Toyoda. Apply oil before the trial run.
Oil Grease
A B C D
E
(For centralized
lubrication)
Kinematic viscosity
Cst
100°C 13–16 13–15 26–30 — —
40°C 135–153 135–155 370–393 — —
Viscosity index 95 or more 95 or more 97 or more — —
Flash point 216°C or above 225°C or above 236°C or above — —
Pour point –12.5°C or below –10.0°C or below 5°C or below — —
Total acid value mgKOH/g 0.85 or less 1.8 or less — — —
Total base value mgKOH/g — 9.5 or less — — —
Sulfated ash % — 12 or less — — —
Soap base — — — Lithium Lithium
Miscibility 25°C — — — 265–295 355–385
Dropping point — — — 175°C or above 170°C or above
Oil percentage % — — — — —
MOS2 particle size µ
(average)
— — — — —
Lubricant type Symbol Lubricating points Quantity per machine
Oil
A
*1
RH cutter and full-leno selvage device
*2
A little
B
Tappet cam box (spun cam specification)
*3
LH & RH tucker housings
9
l
Tappet cam box (filament cam specification)
*3
LH & RH tucker housings
12
l
Grease D Bearings, gears, and springs A little
Symbol
Physical & chemical
properties
Types of lubricants