Toyota 8FBE18T, Руководство оператора, Страница: 26 / 53

26
Hoisting the vehicle
To hoist the vehicle, sling a fiber belt or a wire rope at
the side of the beam on top of the outer mast for the
front side and at the draw bar for the rear side.
Note:
• Before hoisting the vehicle, tilt the mast to the most
backward position.
• Please use protection pad at the roof end.
• Remove the rear combination lamp assembly
before installing the protection pad.
• This illustration is showing the STD mast.
• Be careful not to strain the head guard.
A rope: use a fiber belt or wire rope
B rope: use a fiber belt
Caution Caution Caution
• Before hoisting the vehicle, check that the draw
bar doesn’t move upward.
• If the draw bar moves upward, the vehicle
should put down and the draw bar should be
pushed to the correct position.
• Use fiber belt and wire rope of sufficient
strength.
• Never use the holes on the upper side of the
counterweight to hoist the vehicle.
Rear view mirrors (OPT)
Set mirror angles before vehicle start.
Caution Caution Caution
Do not rely only on mirrors while traveling back-
ward.
Room light (OPT)
The switch (6) turns the room light on/off.
3W 4W
Rope lenght A Approx. 2m Approx. 2m
Rope lenght B Approx. 3m Approx. 3.5m
B
A
6
Heater (OPT)
Operator can adjust the direction of air by registers.
(1) upper register / defroster
(2) middle register
(3) lower register
(4) air filter
(5) heater fan switch
Switch positions:
1 fan OFF, heater OFF
2 fan ON, heater OFF
3 fan ON, heater ON
Caution Caution Caution
Before starting the fans and heater, check if the air
filter is installed.
Cabin and body guard (OPT)
Be sure to close the side doors / gates before traveling.
Caution Caution Caution
Check the conditions of the side doors / gates and
locks. If any anomaly is found, have the vehicle
inspected at a Toyota dealer.
1
2
3
4
5
Cabin
Body guard
(En-25)