Toyota 7BPUE15, Руководство по обслуживанию

Страница: 162 / 411

Toyota Orderpicker Model 15 Service Manual Section 7. Component Procedures
Control Handle
spring with the tangs straddling the pot pull the travel assembly from
bracket pin. See Figure 7- 16. the enclosure. See Figures 7-23 and 7-24.
N
OTE
: Replace the spring if the tangs are not
parallel. Do
not bend the spring.
8. Install the two fiber washers.
9. Install the knob. See
Knob on
page 7-2 1.
Travel Pot (VR 1
)
Disassembly
1. Remove the four hex head cap screws from Figure 7-23. Travel Pot Bracket Screws
the front of the travel pot enclosure and
remove cover. See Figure 7-22.
R e m o v e s c r e w s
Figure 7-24 Travel Pot Enclosure (Cover Removed)
Figure 7-22. Travel Pot Cover Removal 3. Loosen the set screw on the gear two full
turns and slide the off the shaft. See
2. Remove the two pan head machine screws Figure 7-25.
from the back of the enclosure. Carefully
4. Remove retaining n u t and lock washer
from pot and separate from the bracket.
See Figure 7-25.
Figure 7-25. Travel
5. Carefully remove heat shrink tubing from
the terminals and identify the wires so
they can be installed in the same location
on the new pot.
00700-CL222-05, 1 5 March 2005