7509E–01
B55944
B55945
B56621
Installation Hole
Installation Hole
(For Adjustment)
75–22
–
ENGINE HOOD/DOOR
LUGGAGE DOOR HINGE TORSION BAR
2702
Author:
Date:
2002 CAMRY REPAIR MANUAL 185W (RM881U)
LUGGAGE DOOR HINGE TORSION BAR
REPLACEMENT
NOTICE:
Hold the door when opening / closing it in order to prevent the door from closing without any resis-
tance after removing the torsion bar.
1.
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
2.
REMOVE SPARE WHEEL COVER ASSY
3.
REMOVE REAR FLOOR FINISH PLATE(See page
76–4
)
4.
REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER RH(See page
76–4
)
5.
REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH(See page
76–4
)
6.
REMOVE LUGGAGE DOOR HINGE TORSION BAR LH
(a)
Remove the torsion bar RH from the clip placed in the center of the upper back panel.
(b)
Remove the tip of the torsion bar by hand from the roof
side inner panel.
(c)
Take out the hinge arm from the torsion bar in the rear
direction.
(d)
Pull the torsion bar to your side in order to remove the
”U”–shaped part from the hinge support.
7.
REMOVE LUGGAGE DOOR HINGE TORSION BAR RH
8.
INSTALL LUGGAGE DOOR HINGE TORSION BAR LH
(a)
Check the paint mark of the torsion bar. (When installing
a new one)
HINT:
Green paint for a vehicle without rear spoiler
Yellow paint for a vehicle with rear spoiler
(b)
Set the tip of the torsion bar in the installation hole placed
in the center part. Holes placed in the upper and lower
parts are used for adjustment.
