P12478
Adhesive
P15000
SST
LU--2
--
LUBRICATION
OIL AND FILTER
(a)
Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Part No. 08833--00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b)
Using SST, install the oil pressure switch.
9.
START ENGINE AND CHECK FOR LEAKS
10. OIL AND FILTER REPLACEMENT
CAUTION:
SSSS
Prolonged and repeated contact with mineral oil will
result in the removal of natural fats from the skin,
leading to dryness, irritation and dermatitis. In addi-
tion, used engine oil contains potentially harmful
contaminants which may cause skin cancer.
SSSS
Care should be taken, therefore, when changing en-
gine, oil to minimize the frequency and length of time
your skin is exposed to used engine oil. Protective
clothing and gloves that cannot be penetrated by oil
should be worn. The skin should be thoroughly
washed with soap and water, or use water--less hand
cleaner, to remove any used engine oil. Do not use
gasoline, thinners, or solvents.
SSSS
In order to preserve the environment, used oil and
used oil filters must be disposed of only at desig-
nated disposal sites.
11. DRAIN ENGINE OIL
(a)
Remove the oil filler cap.
(b)
Remove the oil drain plug, and drain the oil into a contain-
er.
12. REPLACE OIL FILTER
(a)
Using SST, remove the oil filter.
(b)
Check and clean the oil filter installation surface.
(c)
Apply clean engine oil to the gasket of a new oil filter.
(d)
Lightly screw the oil filter into place, and tighten it until the
gasket contacts the seat.
(e)
Using SST, tighten it an additional 3/4 turn.
13. REFILL WITH ENGINE OIL
(a)
Clean and install the oil drain plug with a new gasket.
Torque:
37 N m (375 kgf cm, 27 ft lbf)
CLICK HERE TO VIEW CHAPTER INDEX
Pages From Supplement
3RZ-F,3RZ-FE
