Before Initial Use
• To maximize the battery capacity, the lights should be charged in direct sunlight for at least 12–24 hours
before being used for the first time.
• The lights should be placed in an area where they are exposed to at least 6-8 hours of direct sunlight. The
area should not be shaded by buildings, trees, walls, etc. since this reduces the ability to charge.
• Avoid placing the lights in areas where other light sources shine on them in the evening. The light will illumi-
nate when motion is detected. If any light is shinning directly on the NITEWATCH PRO it will not work.
Mounting To A Flat Surface
• Open the NITEWATCH PRO so both the solar panel and the lights are facing the same direction.
• Rotate the larger bracket known as the mounting backet (bracket with holes) 90 degrees behind the lights.
• Press the mounting bracket against the flat surface and tilt the solar panel towards you.
• Using a drill or screwdriver, screw the wood screws through the oval holes in the mounting bracket.
• Once secure against the flat surface, angle your light in the desired direction.
• Angle your solar panel to receive maximum sunlight. At least 6-8 hours of direct sunlight is recommended.
• Finally, turn “ON” by pressing the black button located on the front, above the motion detector.
Your NITEWATCH PRO is designed to turn on automatically at night. Do not worry if the lights do not come on at this step if you are installing it during the day.
Staking Into The Ground
• Once fully charged, turn “ON” by pressing the black button located on the front above the motion detector.
• Rotate the unit and the smaller bracket 90 degrees so it is perpendicular with the larger mounting bracket.
• Using a screwdriver, remove the small phillips screw from the ground stake.
• Connect the ground stake to the large mounting bracket by screwing the small phillips screw through the
center hole of the large mounting bracket.
• Stake your NITEWATCH PRO into the ground. Choose a location that receives at least 6-8 hours of sunlight.
• Finally, open the solar panel and light by rotating each to a desired position. With the solar panel facing the
sun and the light facing outward.
Your NITEWATCH PRO is designed to turn on automatically at night. Do not worry if the lights do not come on at this step if you are installing it during the day.
Using The Kickstand
• Once fully charged, open the solar panel and light by rotating each to a desired position. With the solar
panel facing the sun and the light facing outward.
• Rotate the large mounting bracket 45 degrees behind the light and under the solar panel.
• Turn “ON” by pressing the black button located on the front above the motion detector.
• Finally, place the NITEWATCH PRO in the desired location on any flat surface.
Your NITEWATCH PRO is designed to turn on automatically at night. Do not worry if the lights do not come on at this step if you are installing it during the day.
Video Instructions Available
• Check out www.touchofeco.com/NITEWATCH_PRO for step by step instructions on how
to assemble and use your NITEWATCH PRO. Also available on YouTube.com
