Washlet E200 Installation Instructions
Before installing your Washlet, be sure to read the following installation instructions and install the product only as described in this manual.
Safety Precautions
Follow all safety precautions and warnings when
installing the Washlet.
The symbol indicates a prohibited use of the product.
This symbol means "Always follow this precaution".
DANGER
Do not install the Washlet in a wet or damp
place, such as a shower stall or bathtub
area. Doing so may cause fire or electrical
shock.
Prohibited
Use of This
Product:
Only use tap water or drinkable well water
(ground water).Use of water that is not safe
for drinking may cause irritation or injury to
the skin.
This product should be used with grounded
120V, 60Hz electrical current only to avoid
possible fire or shock.
Do not use a loose or faulty electrical outlet
or plug.Doing so may cause fire or electrical
shock.
Make sure that a ground wire has been
installed. Failure to install a ground wire
could result in electrical shock in the event of
a malfunction or short circuit.
Be sure to plug the electrical cord all the way
into the wall socket to avoid possible fire or
electrical shock.
WARNING
Do not raise the toilet seat or
seat cover while objects are
resting on top of the toilet, as
this could cause the main unit
to become detached, resulting
in injury.
After cleaning the water
filter, be sure to insert it
into the drain valve and
securely tighten the drain
valve to avoid water leak-
age.
Do not bend or crush the
connection hose.Bending
or crushing the connec-
tion hose may result in
water leakage.
Do not remove the
drain valve and water
filter with the water
shutoff valve in the
OPEN position.
Do not install base
plate to Washlet
when not attached
to the toilet. Fire or
damage may result.
Before Installing the Washlet
1. Do not transmit electrical current or supply water to the unit until
the installation process is complete.
2. The power voltage is 120V/60Hz. The rated energy consumption
is 410 W. Use wiring and electrical outlet appropriate for this level
of power.
3. The power cord is 3 feet (1m) in length. The electrical outlet
should be installed on the wall to allow easy installation and
removal of the Washlet .
4. Use a water supply of 20 - 80 PSI (0.14Mpa ~ 0.55Mpa).
5. The water temperature range should be 0 ~ 35
°
C (32~95
°
F).
6. The length of the connection hose is 1.5 feet (500mm). The water
supply should be installed to allow easy installation and removal of
the Washlet.
Water drainage
plug
Release button
for removing the
main unit
Lid
Label
Heated toilet seat
Wand
Base plate
Remote controller
Power plug
Connection hose
Toilet seat sensor
Main unit
Junction valve
Parts Identification
Parts and Features
Remote controller
Remote controller
wall hanger
Anchor bolts (3)
Screws (3)
Remote controller batteries
(2 AA batteries)
Bolts (2)
Washers (round, 2)
Washers (lock, 2)
Stopper (2)
Rubber bushing (2)
Base Plate
Template
¶
Washlet Main Unit
Ë
Remote Controller Parts
Ì
Base Plate Parts
Î
Junction valve
Í
Connection Hose
(with packing washer)
Ï
Instruction Manual
Warranty Card
Installation Instructions
Use second set of mounting holes for
decoratively curved toilets.
Ð
Washers (2)
½
Optional Elbow Joint
2004.9.27 D06694S