Hardware Installation
The RJ11 port of this Modem Router can only connect to ADSL Filter. Please follow steps in below diagram in correct order.
1. Please disconnect the power adapter and all cables during thunderstorm weather;
2. Keep away from heat source and keep well ventilated;
3. Please pay attention to the waterproofing and moisture-proof when storing,
transporting and running.
4. The power supply must reach the rated current and power.
5. Put the router in flat places.
Set Up PC
For Windows 2000 or Windows XP Operating System, please comply with following steps to set up.
Right-click “My Network
Places”, click “Properties”
Right-click “Local Area
Connection”, click “Properties”
Double-click “Internet Protocol
(TCP/IP)”
Choose “Obtain an IP address
automatically” and “Obtain DNS
server address automatically”,
click “OK”; go back to previous
interface and click “OK”
For Windows Vista or Windows 7 Operating System, please comply with following steps to set up.
Click “Start— Control Panel— Network
and Internet— Network Connection”,
right-click “Local Area Connection”,
and choose “Properties”.
Double-click “Internet Protocol
Version 4 (TCP/IPv4)”
Choose “Obtain an IP address automatically”
and “Obtain DNS server address automatically”,
click “OK”; go back to previous interface and
click “OK”
Quick Installation Guide
Wireless N ADSL2+ Modem Router
Set Up Router
Please set up the router following below steps.
Run the Web browser.
Type http://192.168.1.1 in the web browser, then press Enter.
Wireless Network Connection
Right-click “My Network
Places”, click “Properties”
Right-click “Wireless Network
Connection”, and click “View
Available Wireless Networks”
Confirm the wireless network SSID name,
choose one that you would like to connect,
then click “Connect”
Input the encrytion key and click “Connect”
Have connected wireless network, you can access
Internet through wireless mode.
For more information, please go to www.totolink.net
Input the Username and Password, then click Login button
(The default Username and Password is admin).
Choose Easy Setup. Select the language according to your country
and click NEXT (The default language is English).
NOTE:
Information in this document is subject to change without prior notice.
NOTE:
After you set the Pre-Shared Key, please remember your SSID and
the Pre-Shared Key to connect with your wireless LAN.
Telephone
Cable
Telephone Cable
Telephone
Cable
Power Adapter
ADSL Splitter
Network
Cable
PC
Fill in the related content based on the information provided
by your ISP, click Next.
5
Setup the wireless parameters, then click APPLY to save your settings.
6
Now, you have finished Easy Setup, click CLOSE.
7
Suitable for: ND150,ND300
V.14.10
2015
DC IN
POWER
ADSL
1 LAN/WAN
2/3/4 LAN
This socket is used to connect the power adapter.
This button is used to power on or off the ADSL Router.
This RJ11 ADSL port is used to connect to the ISP.
This port is used to connect the router to the local PC/ Internet.
These ports are used to connect the router to local PC.
This button is used to power on/off the WiFi signal.
WiFi
WPS/RST
Press the button for more than 5 seconds, the router will restore factory settings.
For less than 5 seconds, the router will establish Wi-Fi protected settings(WPS)
automatically.
Ports and Buttons Description
FAQ
How to find the IP address and user name & password
on the device?
5
How to reset the router to default factory settings?
1.When the router is powered on, press the WPS/RST button for about 10s.
2.The router’s CPU LED indicator keeps flashing, which means you have
reset your router to default settings successfully.
On the rear panel of the Router, there is IP address, User name and
password printed on the sticker. See below:
