QUICK START GUIDE
For those familiar with e-cigarettes, the steps below can
be followed to allow the device to be used in the shortest
possible time:
• Prime the atomizer head
• Fill the tank
• Switch the Skope S on
• Press the power button and inhale
• Charge the battery (it may not have been shipped with
a full charge)
USING YOUR SKOPE S
Priming the Atomizer Head
Note: It is important to “prime” a new atomizer head before first use. Failure to do so
can cause the atomizer coil to overheat, leading to an unpleasant taste and sometimes
irreversible damage to the atomizer head requiring early replacement.
To prime the atomizer head, remove the mouthpiece from the tank by unscrewing, then
remove the glass section of the tank by pulling upwards. Unscrew the atomizer head and
prime by dripping a few drops of e-liquid onto the cotton visible through the sides of the
atomizer. After priming, screw the atomizer head back into place, replace the glass section
and screw the mouthpiece back on.
Filling the Tank
Remove the mouthpiece from the tank by unscrewing.
Fill the tank with e-liquid, being careful not to overfill and
avoid filling down the central airflow hole. Once filled,
refit the mouthpiece.
Powering On and Off:
To switch on, quickly press the power button five times;
the indicator light will flash three times. Quickly press the power button five times to turn
the battery off; the indicator light will flash three times.
Vaping:
Press and hold the power button as you inhale the vapour.
Power
Button
Charging Port
Skope S
Tank
Skope S
Battery
Note: Leave a new
atomizer head to sit with
the tank full of e-liquid
for five minutes before
vaping. This ensures the
atomizer head is fully
saturated with e-liquid
before use.
USER MANUAL
CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED SKOPE S ELECTRONIC CIGARETTE KIT
