610, 650, 670, 675
Quick Start Guide
Copyright © Tosibox Oy, 2021
Matching your TOSIBOX
®
Node with the Key
Connect to the Internet using Ethernet connection
1
3a
1. Connect the operating voltage of 9-50 V DC to the Node and wait for 1 minute.
2. Insert the Key into the USB port of the Node. When the LED on the Key turns off, (after approx.
10 seconds) the matching is complete, and you can remove the Key from the USB port.
3. Go to
3a
if you are connecting to the Internet using Ethernet connection or
3b
if setting up
wireless connection. If deploying Nodes as DHCP client into existing networks, please see the
TOSIBOX
®
user manual.
1.
Connect your TOSIBOX® Node from the WAN port to the Internet with a fixed Ethernet cable.
2.
When the WAN ETH LED is lit on the front plate of the Node, the Internet connection is working. If the
light is not lit, investigate possible connectivity issues.
3b
Connect the device to the Internet using internal
LTE Modem
(670 and 675)
You can connect the device to the Internet with an
internal Modem. Before inserting or removing the SIM
card, disconnect the device power supply.
1.
Install the antenna
2.
Insert a SIM card
3.
Select Network > Internal Modem and fill in
the APN according to your mobile operator
settings. Enter PIN code if necessary.
Click Save.
Connect the device to the Internet using wireless LAN
(650 and 675)
1.
Attach WLAN antenna to the device.
2.
Open the service connection to the device and
log in with your credentials.
3.
Configure wireless LAN settings at “Network
> WLAN”.
4.
When the WAN WIFI LED is lit on the front plate
of the Device, the WLAN connection is working.
Set up wireless connection
Position the antennas in orthogonal pattern, i.e. in such a way that they form
90 degrees angle between each other.
!
1.
Connect ethernet cable into LAN port of TOSIBOX® Node and
the other end of the cable into LAN port of your computer.
2.
Visit 10.10.10.254 in your browser to set up your device.
3.
Log in using “admin” account. The password can be found from the bottom of the Node.
4.
TOSIBOX® Node needs an Internet connection to function. Go to if deploying into broadband
networks (ethernet) or if deploying into wireless connection.
3a
3b
Set Up Router
2
Update the device software immediately when you are connected to the Internet.
Go to Settings > Software update. If there is a software update available for the device, start the update by
clicking Start software update.
!
