Toshiba TDP-SP1, Руководство пользователя

Страница: 23 / 46

23
Preparations
Connection
Before connection
• Read the owner’s manual of the device you are connecting to the projector.
• Some computers cannot be used with or connected to this projector.
Check for an RGB output terminal, supported signal p.43 , etc.
• Turn off the power of both devices before connecting.
• The figure below shows sample connections. This does not mean that all of these devices
can or must be connected simultaneously.
Notes
• Moving pictures played back on computers using DVD software may appear unnatural
when projected with this projector. However, it is not a malfunction of the projector.
• When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
• Output volume of AUDIO OUT terminal can be adjusted by the
VOL+/-
button.
• The MONITOR OUT terminal outputs analog RGB signals or component video signals
(Y/P
B
/P
R
) from the COMPUTER IN terminals.
• A computer monitor usually cannot accept Y/P
B
/P
R
signals correctly.
Computer (for control) Monitor
To RS-232C
terminal
To audio output
Audio cable
(not supplied)
Control cable
RGB cable
(supplied)
To RGB output
Computer
To audio input
Audio cable
(not supplied)
Video cable
(not supplied)
To S-video output
To video output
S-Video cable
(not supplied)
p.45