Chapter 4. Using and maintaining the 4610 printer
Using and maintaining the 4610 printer
This section contains information about the proper use and maintenance of the 4610 Model 2CR
and 2NR printers. For detailed technical information, see Chapter 2, Product specifications on
page 27.
Attention: All covers must be installed on the SureMark printers during operation.
Replenishing consumable supplies
You are responsible for replenishing consumable supplies, which includes:
• Paper rolls
• Inserted forms
• Ribbon cartridges
paper rolls. Make sure that you are using the recommended supplies for the 4610 Model 2CR
and 2NR printers, which are described in the following sections.
Loading and replacing the paper roll
The 4610 printers can accommodate a four inch printer roll. When your paper roll is running
low, the paper supply LED indicator will blink continuously. Once the paper is out, the amber
(orange) light of the paper supply LED indicator will remain lit until you replace the roll.
Important: See “Supported paper types” on page 40 to verify that you are using the correct
paper for the 4610 Model 2CR and 2NR printers.
To properly install the paper roll, make sure you install the paper with the printing side facing
out. The paper should not be attached to the core in any manner. To load a new paper roll,
complete the following steps:
P
Figure 19. Opening the paper door
©
Copyright Toshiba Global Commerce Solutions, Inc. 2017
39
Содержание SureMark 4610 2CR
