Dialogic Boards
Basic Settings for Voice Boards
26
Strata CIX ACD Installation 06/2012
Basic Settings for Voice Boards
This step covers the basic settings for the Dialogic peripheral boards. The following voice boards
are available for installation in the Strata ACD:
•
D/4PCI
•
D/4PCIUF
•
D/120JCT-LS
Note
It is recommended that the voice boards start at the D0000 memory address.
Adding or removing a board can cause the renumbering of boards in the system, depending upon
the PCI bus and slot number where you install it. Consequently the assignment of device names
may change during the next system start up.
Also, PCI boards that use ID 0 for the geographical numbering sequence will be numbered before
boards that use board IDs I-F.
Board Numbering
Important!
All boards must be set to the factory default of 0.
Analog Voice Boards
D/4PCI, D/4PCIUF
Check rotary switch SW1 (shown below) to verify that it is set to 0.
Table 4-1
D/4PCI, D/4PCIUF Parts Description
Part
Function
SW1
Board slot ID switch
SW4 (D4PCI Only)
Slide switches to set hookswitch state for start-up.
J1~J4
RJ11 jacks to connect to 4 PBS or public telephone
network lines.
J1
J2
J3
J4
SW1
SW4
PC I
Rear Bracket
Bus Connector
7438
J1
J2
J3
J4
SW1
PC I
Rear Bracket
Bus Connector
1pcd
D/4PCI
D/4PCIUF
Содержание STRATA CIX Effective Call Center Management
Страница 10: ...This page is intentionally left blank ...
Страница 14: ...This page is intentionally left blank ...
Страница 18: ...This page is intentionally left blank ...
Страница 24: ...This page is intentionally left blank ...