Toshiba Strata AirLink DK40i, Руководство по установке и обслуживанию

Страница: 509 / 724

Strata DK I&M 6/00
12-1
Pe
ri
p
h
er
a
l In
st
al
la
ti
on
Peripheral Installation
12
This chapter provides connection procedures for optional peripheral equipment to Strata DK
Systems. Information in this chapter applies to all systems, unless stated otherwise in text.
Instructions include hardware requirements, PCB configuration, interconnection/wiring
requirements, and programming considerations. Peripheral equipment is connected to system
PCBs. See
Chapter 9 – Universal Slot PCBs installation and configuration information and the
appropriate installation section.
Power Failure Options
In the event of a power failure, Strata DK uses these options:
Reserve Power
For information on the Reserve Power Option, see the appropriate installation chapter.
DK14/DK40i Single-line Power Failure Emergency Transfer
DK14 and DK40i have a built-in single-line Power Failure Emergency Transfer (requires loop
start lines). See
Chapter 1 – DK14 Installation and Chapter 3 – DK40i Installation for detailed
information.
DK40i/DK424 Power Failure Transfer Unit
An optional Power Failure Transfer Unit (DPFT) can be installed that automatically connects up to
eight selected CO lines directly to designated standard telephones in the event of a power failure.
The DPFT enables normal operation of the selected CO lines and standard telephones when the
system is in service. When power is restored, each telephone is independently reconnected to
system standard telephone circuit ports after it is finished with its direct CO line call. The DPFT is
normally installed on the MDF.
Figure 12-1 provides a circuit diagram of the DPFT.