Program *44-3 Incoming Digit Translation (Tie Lines)
System & Station
Strata DK40 Programming Manual Spring 1999
3-105
Program *44-3
Incoming Digit Translation (Tie Lines)
Program Type:
Toll Restriction
Initialised Default:
Initialised Data is Blank
Note
By Pressing “Key 1” = I/P Don’t Care
“Key 2” = I/P Don’t Care
If Key 1 is used to I/P X2 then translation will be performed on the first digit X1 only
If Key 2 is used to I/P X2 then translation is performed on the first digit X1, but the digit
X2 is deleted from the incoming number
Program *44-3 Overview
Enables the system to translate the first two digits it receives. Up to a maximum of five
different translations can be programmed.
Example: If in Program 44-31 the data entered was 60 200, this would allow the system on
receipt of the digits 60, to translate them and actually dial 200.
(QWHU 3URJ 0RGH
0
6SNU
*
7 7
+ROG
6SNU
6
;
4
;
5
<
4
<
5
<
6
+ROG
0
6SNU
& &
+ROG
0
6SNU
& &
+ROG
Number to be translated
Translation
X1
X2
Y1
Y2
Y3
31
32
33
34
35
Enter up to three digits that X1 and X2 must
be translated to
Enter 1 - 5
Enter one of the five translations
that can be programmed in
Enter up to two digits that must be
translated
Содержание Strata AirLink DK40
Страница 1: ...Spring 1999 726 Telecommunications Division Programming Manual ...
Страница 22: ...Introduction Related Documentation xxii Strata DK40DK40 Programming Manual Spring 1999 ...
Страница 246: ...System Station Program 97 Printing Program Data through SMDR 3 188 Strata DK40 Programming Manual Spring 1999 ...
Страница 378: ...GL 8 Strata DK40 Programming Manual Spring 1999 ...