Toshiba SD-2550A, Руководство по обслуживанию

Страница: 54 / 109

2-6
2-1-3. Tray Panel
<Tray Ejection>
1. Slide the slider (2) of the mechanism chassis assembly
(1) with a screwdriver, etc. in the arrow direction, so
that the tray (3) is ejected.
Note:
• Take care not to damage the pickup and other parts.
Fig. 2-1-14
<Tray Panel Removal>
1. Eject the tray (3).
2. Twist the tray panel (4) a little in the arrow A direction
with the tray (3) hold by hand to release two claws and
lift up the tray panel (4) in the arrow B direction, then
the tray panel (4) is removed. (Refer to Fig. 2-1-15.)
3. When mounting the tray panel (4), insert the tray panel
(4) along the grooves of the both sides of the tray (3)
until clicking.
Mechanism
chassis assembly (1)
Tray (3)
Front panel
Screw
driver
Slider (2)
Fig. 2-1-15
2-1-4. Front Panel and Tray
1. Remove the flexible cable (1).
2. Release four claws and remove the front panel (2).
3. Pull out the tray (3) towards you.
Fig. 2-1-16
Note:
• Insert the tray (3) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear (4) as shown in the figure
“A”, insert the tray (3). When inserting a tray (3), push
the rack gear side shown by the arrow.
Tray
panel (2)
Tray (1)
Tray (1)
Tray
Panel (2)
Claw
Claw
A
A
B
Front
panel (2)
Tray (3)
Claws
Claw
Flexible cable (1)
Claw