Toshiba RAV-SP804ATJP-E, Руководство по установке, Страница: 49 / 56

- 48 -
Verifying an abnormal state in the past although the abnormal state no longer occurs
1. Set bit 1 of DIP switch SW803 to ON.
2. Jot down the states of LED800 to LED804. (Display mode 1)
3. Press SW800 for at least 1 second. The LED status changes to display mode 2.
4. Find an error whose display mode 1 equals the LED states jotted down and display mode 2 equals the current
flashing states of LED800 to LED804 from the following table to identify the error.
• An outside
air temperature (TO) sensor error can be checked only while it occurs.
( :OFF :ON :Flashing)
No. Cause
Display mode 1 Display mode 2
D800 D801 D802 D803 D804 D800 D801 D802 D803 D804
1 Normal
2 Discharge (TD) sensor error
3 Heat exchanger (TE) sensor error
4 Heat exchanger (TL) sensor error
5 Outside air temperature (TO) sensor error
6 Suction (TS) sensor error
7 Heat sink (TH) sensor error
8
Outdoor temperature sensor (TE/TS)
connection error
9 Outdoor EEPROM error
10 Compressor breakdown
11 Compressor lock
12 Current detection circuit error
13 Thermostat for compressor activated
14
Model data not set (on the service P.C.
board)
15 MCU-MCU communication error
16 Discharge temperature error
17
Abnormal power (open phase detected or
abnormal voltage)
18 Heat sink overheat
19 Gas leak detected
20 4-way valve reverse error
21 High pressure release operation
22 Outdoor fan motor error
23 Compressor driver short-circuit protection
24
Position detection circuit error in one-line
display
* The LEDs and DIP
switches are located
on the lower left of
the P.C. board of the
outdoor unit.
SW801
SW804
SW800
LED
ON
123
4
SW803
ON
123
4
SW802
ON
123
4
D800
D801
D802
D803
D804
D805
D800
D801
D802
D803
D804
D805
Enlarged view of
LEDs
EN-95 EN-96