Toshiba RAV-SM561KRT-E, Руководство пользователя, Страница: 21 / 33

17
TOSHIBA 1075000646_EN
EN
When you use the air conditioner for the first time or when you change the SET DATA value, follow the procedure below.
From the next time, the operation displayed on the remote controller will start by pushing the
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
•
When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but it is
not a failure. (
lamp lights up at this time.)
1 1 1 1 1
Push button.
The operation lamp goes on, and the operation starts.
2 2 2 2 2
Select an operation mode with the “MODE”
button.
One push of the button, and the display changes in the
order shown on the right.
•
In HEAT mode, if the room temperature reaches to the set temperature, the outdoor unit stops and the air
flow becomes LOW and the air volume decreases.
•
In the defrost mode, the fan stops so that cool air is not discharged and STAND BY is displayed (remote
controller and main unit).
3 3 3 3 3
Select air volume with “FAN ” button.
One push of the button, and the display changes in the
order shown on the right.
•
When air volume is “AUTO ”, air volume differs according to the room temperature.
•
In DRY mode, “AUTO ” is displayed and the air volume is LOW.
•
In heating operation, if the room temperature is not heated sufficiently with VOLUME “LOW ” operation, select
“MED ” or “HIGH ” operation.
4 4 4 4 4
Determine the set up temperature by pushing the “TEMP. ” or “TEMP. ” button.
Stop
Push button.
The operation lamp goes off, and the operation stops.
CORRECT USAGE
•
While using the air conditioner, operate it only with button without turning off the main power switch
and the leak breaker.
REQUIREMENT
UNIT
SET CL
1
2
3
4
AUTO HEAT DRY COOL FAN
LOW MED. HIGH AUTO
01(EN)_1075000646 P14-20 7/16/04, 13:34 17
3