33
SV
FI
NO
DK
EN
REMOTE CONTROL A-B SELECTION
Start the operation smoothly and reduce the operating noise.
l
Cooling or Heating starts after 10 seconds with a “Pi” sound. However, continue to press it.
Setting completes when the “Pi” sounds 5 times and the operation lamp blinks.
l
To cancel it, repeat the above operation (in this case, the operation lamp does not blink)
Press for 20 seconds
20 seconds
To separate using of remote control for each indoor unit in case of 2 air conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold
button on the Remote Control by the tip of the pencil. “00” will be shown on the display. (Picture
1
)
4. Press
02'(
during pushing
. “B” will show on the display and “00” will disappear and the air conditioner will turn OFF. The Remote Control B is memorized.
(Picture
2
)
Note:
1. Repeat above step to reset Remote Control to be A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory is A.
1
2
Quiet
CONCERN ABOUT THE OPERATING
NOISE
TROUBLESHOOTING
(CHECK POINT)
The unit does not operate.
Cooling or Heating is abnormally low.
l
The power main switch is turned off.
l
The circuit breaker is activated to cut off the power supply.
l
Stoppage of electric current
l
ON timer is set.
l
The
fi
lters are blocked with dust.
l
The temperature has been set improperly.
l
The windows or doors are opened.
l
The air inlet or outlet of the outdoor unit is blocked.
l
The fan speed is too low.
l
The operation mode is FAN or DRY.
01_1118350236_EN.indd 33
01_1118350236_EN.indd 33
8/8/2560 BE 12:04
8/8/2560 BE 12:04
