54
Getting Started
Removing a memory module
Always make sure your computer and AC adaptor have
adequate ventilation and are protected from overheating
when the power is turned on or when an AC adaptor is
connected to a power outlet (even if your computer is in
Sleep mode). In this condition, observe the following:
❖
Never cover your computer or AC adaptor with
any object.
❖
Never place your computer or AC adaptor near a
heat source, such as an electric blanket or heater.
❖
Never cover or block the air vents including those
located at the underside of the computer.
❖
Always operate your computer on a hard flat
surface. Using your computer on a carpet or other
soft material can block the vents located at the
underside of the computer.
Overheating your computer or AC adaptor could cause
system failure, computer or AC adaptor damage or a fire,
possibly resulting in serious injury.
19
Reconnect the cables.
20
Restart the computer.
TECHNICAL NOTE: You must have at least one memory
module installed for the computer to work.
You can now continue setting up the computer. When the
operating system has loaded, you can verify that the
computer has recognized the additional memory module.
If you are adding extra memory after setting up the
computer, verify that the computer has recognized it
correctly as described in
.
Removing a memory module
If you need to remove a memory module:
1
“Installing a memory module” on
to shut down the computer and open the
memory module slot cover.
