Page 8
Hardware
2.1
Installation Instructions
The OIS60 should be mounted on a panel. Gasket, mounting clamps are provided with each OIS60 unit
for proper mounting.
Environmental Considerations:
Make sure that the unit is installed correctly and that the operating limits are followed (see Specifications
for OIS60).
Do not operate OIS60 in areas subject to explosion hazards due to flammable gases, vapors or dusts.
OIS60 should not be installed where fast temperature variations are present. Highly humid areas are also
to be avoided. High humidity causes condensation of water in the unit.
Location Considerations
Care should be taken when locating equipment behind the OIS to ensure that AC power wiring, PLC
output modules, contactors, starters, relays and any other source of electrical interference are located
away from OIS60.
Particular care should be taken to the position of Variable speed drives and switching power supplies
away from the OIS60.
Panel Mounting
This section presents the dimensional sketches and panel cutouts for OIS60 model.
All dimensions are in mm. Not to Scale.
Panel Cutout : 183.20 mm x 125.20 mm
Mounting
Screw
63.56
197.00
182.20
139.00
68.56
124.20
Gasket
Panel
Bezel
41.50
Clamp
12345678
12345678
58.50
123456789
123456789
12345678
12345678
Содержание OIS Series
Страница 71: ...Page 67 Frequently Asked Questions 7 FREQUENTLY ASKED QUESTIONS In this Chapter How Do I Ø ...
Страница 73: ...Page 69 Diagnostics and Maintenance 8 DIAGNOSTICS AND MAINTENANCE In this Chapter Diagnostics Maintenance Ø Ø ...
Страница 76: ...v Appendix APPENDIX In this Chapter Cable Diagrams Order Numbers for Model and Cables Ø Ø ...