23
perform this function.
Focus Mode
There are three modes to choose, the default is ‘Auto’.
Manual:
Press NEAR and FAR to control focus on the PTZ Control
interface.
Auto:
The Auto mode automatically adjusts the focus position to the
best of the picture in a center. Also, change near/far to Focus Near and
Focus Far on the PTZ Control interface. After this change, camera
became ‘Manual’ mode once, and getting back ‘Auto’ mode if you click
PTZ operation.
Zoom Trigger:
Under this mode, camera will remain as ‘Manual’ mode
unless it receives zoom in or zoom out signal, and after the designated
action it will back to ‘Manual’ mode.
Focus Sensitivity
You can set is as Normal (default) or Low.
When the lighting level is low, the Auto Focus function does not take
effect. At that time, you can set to ‘Low’.
Focus Correction
Set ‘Standard’ normally. If you light the IR illuminator and the camera
was unfocussed, set to 'IR Light'.
Day-Night
Set DAY/NIGHT function. Move the cursor to select the AUTO (default),
Day, or Night mode.
AUTO:
The IR Cut filter can be disengaged automatically to
increasing sensitivity in low light environments.
NOTE:
Although hunting may occur under the conditions of
specific brightness, it is not a malfunction.
Day:
You can force the camera to stay in DAY (COLOR) mode.
Night:
You can force the camera to stay in BW (NIGHT) mode.
Zoom Limit
You can choose x20(default, optical), x40(x20 o x2 digital),
x80(x20 o x4 digital), x160(x20 o x8 digital), x240(x20
o x12 digital).
DNR
You can configure the noise reduction related setting from 0 to 5 and
reduce noise on the screen. ‘0’ means OFF and ‘5’ is the maximum.
(Default is 3.)
WDR(Wide Dynamic Range)
Содержание IK-WP41A
Страница 42: ...41 Network Settings Basic ...
