17
17
17
Ceiling/Wall Mount without Mounting Plate
(Choose this mounting type if you want to feed the cables from the bottom of
the camera)
1
2
3
7
8
5
1. Attach the supplied alignment sticker for camera main unit to the ceiling/wall.
2. Using the three circles on the sticker, drill three pilot holes (Ø1/4inch x 1.57inch(D)
(Ø6.35mm x 40mm(D))) into the ceiling. Then hammer the three supplied plastic anchors into
the holes.
3. Drill a cable hole (Ø0.8inch(Ø20mm)) on the ceiling/wall, and feed the cables through the
hole.
4. Connect the LAN cable to the socket (Refer to the page 14.).
5. Secure the camera main unit to the ceiling/wall with three supplied screws.
6. You will find a silica gel bag attached to the camera. Replace the silica gel bag included in
the camera with the one shipped within the accessory.
7. Attach the dome cover.
8. Secure the four screws with the supplied torx driver. Make sure all camera parts are securely
installed.
l
The included screws and anchors are used to
install the camera to a solid surface. (e.g. concrete)
If installing on loose or thin material surfaces , use
the appropriate anchors (not included) with the
screws.
l
Arrange the cables neatly to avoid getting in
the way when the dome cover is attached.
NOTE
6
