9
8
Viewing
・
Listening
and Operation
Others
Set up
Introduction
Recording
Viewing
・
Listening
and Operation
Others
Set up
Introduction
Recording
9. Ventilation
This camera should never be placed near or over a radiator or heat register.
This camera should not be placed in a built-in installation such as a bookcase
or rack unless proper ventilation is provided or the manufacturer's instructions
have been adhered to.
10. Power Sources
This camera should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supply to your
location, consult your product dealer.
11. Power-Cord Protection
Power-Supply cords should be routed so that they are not likely to be walked
on or pinched by items placed upon or against them, paying particular attention
to cords at plugs, screws and the point where they exit from the product.
12. Installation
This camera should be installed on a firm and solid part of the ceiling or wall. If
installed on a soft and weak place, the camera unit may fall. A person under it
may be injured and things under it may be damaged.
13. Lightning
For added protection for this camera during a lightning storm, or when it is left
unattended and unused for long periods of time, unplug it from the outlet and
disconnect the power supply and cable system. This will prevent damage to
the camera due to lightning and power-line surges. If lightning occurs, do not
touch the unit or any connected cables in order to avoid electric shock.
14. Overloading
Do not overload power supply and extension cords as this can result in a risk
of fire or electric shock.
15. Object and Liquid Entry
Never push objects of any kind into this camera through openings as they may
touch dangerous voltage points or short-out parts that could result in a fire or
electrical shock. Never spill liquid of any kind on the camera.
IMPORTANT SAFEGUARDS (Cont.)
16. Servicing
Do not attempt to service this camera yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
17. Damage Requiring Service
Disconnect this camera from the power supply and refer servicing to qualified
service personnel under the following conditions.
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the camera.
c. If the camera has been exposed to rain or water.
d. If the camera does not operate normally by following the operating
instructions in the instruction manual. Adjust only those controls that are
covered by the instruction manual as an improper adjustment of other
controls may result in damage and will often require extensive work by a
qualified technician to restore the camera to its normal operation.
e. If the camera has been dropped or the cabinet has been damaged.
f. When the camera exhibits a distinct change in performance-this indicates a
need for service.
18. Replacement Parts
When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer with the same characteristics
as the original part. Unauthorized substitutions may result in fire, electric shock
or other hazards.
19. Safety Check
Upon completion of any service or repairs to this camera, ask the service
technician to perform safety checks to determine that the camera is in proper
operating condition.
