79
Viewing
・
Listening
and Operation
Others
Set up
Introduction
Recording
78
Viewing
・
Listening
and Operation
Others
Set up
Introduction
Recording
Camera/Audio Settings
Set audio input to and output from the network camera.
1
Click "Camera Settings" on the Admin. Menu.
･ A sub menu for Camera Settings will appear.
2
Click "6. Audio" in the sub menu.
･ The screen of "Camera - Audio" will appear.
3
Configure each setting items.
･ Click the Save button to save settings.
･ The settings will not be reflected unless the Save button is clicked.
● Audio Input
Set audio input.
ON: The camera receives audio.
OFF: The camera does not recieve audio.
･ Set to "ON" when inputting audio from a microphone connected to the
camera.
● Audio Input Level
An audio input level is set.
HIGH:
Increases the audio input level.
MIDDLE:
Adjusts the audio input level to a medium level.
LOW:
Reduces the audio input level.
● Audio Output
Set audio output.
ON: The camera receives audio.
OFF: The camera does not recieve audio.
･ Set to "ON" when outputting audio from a microphone connected to
the camera.
● Audio Output Level
An audio output level is set.
HIGH:
Increases the audio output level.
MIDDLE:
Adjusts the audio output level to a medium level.
LOW:
Reduces the audio output level.
● E-mail Address List
1) Set ON or OFF in "Always Sent to Administrator E-mail Address."
ON: Always send to administrator E-mail address.
OFF: Not send to administrator E-mail address.
2) Enter "Mail-to Address." (Up to ten addresses)
3) Check send conditions.
Alarm In:
E-mail is sent to checked addresses when camera
detect alarms.
Motion Detection: E-mail is sent to checked addresses when camera
motion is detected.
NOTE
●
POP is a protocol for receiving e-mail from e-mail box. As the network camera
does not receive e-mail, e-mail in POP server will not be lost due to this
setting.
●
The e-mail function of the network camera is not compatible to "SMTP Auth."
●
The frame rate deteriorates if resolution of "Attached Image Size" differs
from "Resolution" in "1. General" of "Camera Settings".
●
When wishing to send e-mail to administrator's address only in case of either
"Alarm In" or "Motion Detectoin", set to "OFF" in "Always Send to Administrator
E-mail Address", add the Administrator E-mail address to "Mail-to Address"
and check one of "Send Conditoins."
Camera/E-mail Settings (Cont.)
