Toshiba E-STUDIO2008A, Руководство по обслуживанию, Страница: 412 / 1016

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 28
6.4.8 Adjustment of image density
The image density level can be set at the following codes.
< 05 Adjustment Mode >
<Procedure>
(1) Performs FS-05.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the button.)
(5) Press the [OK] button to store the value in memory. The equipment goes back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Press the [TEST COPY] button and then select an original mode. Then press the [START] button
to perform test copying.
(8) If the desired image density has not been attained, repeat step (2) to (7).
Code
Item to be adjusted Remarks
Text/
photo
Text Photo
7218-0
to 4
7219-0
to 4
7220-0
to 4
Adjustment of image
density
When the value is decreased, text becomes lighter.
Acceptable values: 0 to 10
Notes:
1.
Set not to reverse the large and small
number of the setting value
corresponding to the sub code.
Ex.) When the image density level for
7218-0, 7218-1, 7218-2, 7218-3, and
7218-4 is assumed to be “A”, “B”, “C”,
“D”, and “E” respectively, they should
have the following correlation:
2.
Remember that the image
specifications and life span of the
replacing parts may not meet the
standard when the setting value is
changed from the default value.
A B C D E