Toshiba E-Studio 5540c, Руководство по обслуживанию

Страница: 606 / 1499

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 58
6.3.4 Adjustment of faint text
The faint text can be improved in the following codes.
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value. (To correct the value once keyed in, press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory.

The equipment goes
back to the ready state.
(5) For resetting the value, repeat step (2) to (4).
(6) Let the equipment restart and perform the printing job.
(7) If the desired image has not been attained, repeat step (1) to (6).
6.3.5 Upper limit value at Toner Saving Mode
The upper limit value of the density when “Toner save” is selected in the Custom tab of the printer driver
can be adjusted.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of
 P. 6-52"6.3.2 Gamma balance adjustment (Black Mode)".
Black mode Color mode
Remarks
PS PCL XPS PS PCL XPS
7340 7341 7342 8130 8131 8132 When the small characters or fine lines in a
halftone image are faint, they can be improved
by increasing the value to raise the density level.
Acceptable values: 0 to 8 (Default: 0)
Color PS PCL XPS Remarks
Black mode
(600dpi)
7307-0 7307-1 7307-2 The smaller the value is, the lighter the
density of image becomes.
Acceptable values: 0 to 255
Color mode
(600dpi)
8160-0 8160-1 8160-2
Black mode
(1200dpi)
7302 --- ---
Color mode
(1200dpi)
8161 --- ---