Toshiba e-studio 2555c, Руководство по обслуживанию

Страница: 620 / 1558

e-STUDIO2555C/3055C/3555C/4555C/5055C © 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 64
[E061]Incorrect paper size setting for 1st drawer
[E062]Incorrect paper size setting for 2nd drawer
[E063]Incorrect paper size setting for PFP upper drawer
[E064]Incorrect paper size setting for PFP lower drawer
[E065]Incorrect paper size setting for bypass tray
If any paper remains in the equipment or drawer, remove it. Match the paper size of the drawer
setting and the one in the drawer.
* Paper size detection is performed at the first sheet of paper when the drawer is opened or closed, or
when the power of the equipment is turned ON.
[E090]Image data delay jam
[E091] Motor on time-out jam
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]ON/[0]/[C]
PFP lower drawer feed sensor 03-[FAX]ON/[0]/[D]
Bridge unit Bridge unit Bridge unit transport sensor-1
(Entrance sensor) 03-[ALL]OFF/[0]/[A]
Bridge unit transport sensor-2
(Exit sensor) 03-[ALL]OFF/[0]/[B]
Finisher Finisher door Sensors in the finisher -
Classification Error item
Other paper jam Image data to be printed cannot be prepared.
Check item Measures
Other • Remove the paper remained in front of the registration
sensor)
• Check if the error is cleared by turning the power OFF and
then back ON.
SYS board • Connector check
• Main memory check
• Board check
LGC board • Connector check
• Board check
HDD • Connector check
• HDD check
Replace parts Remarks
SYS board
LGC board
HDD
Main memory
Classification Error item
Other paper jam The equipment does not operate normally because
abnormality occurred on an interface between the SYS board
and engine firmware.
Jamming area Cover Sensor Test Mode/Input check