Toshiba e-STUDIO 2020c, Быстрый старт

Страница: 26 / 78

Chapter 1 PREPARATIONS
2
Turning the power OFF (Shutdown)
When turning OFF the power of the equipment, be sure to shut it down according to the procedure below. Check the
following three points before shutdown.
No jobs should be left in the print job list.
None of the PRINT DATA, MEMORY RX and LINE lamps should be blinking.
(If the equipment is shut down while any of the above lamps is blinking, jobs in progress such as FAX reception will be
aborted.)
No PC should access the equipment via the network.
•
•
•
Notes
Use the [POWER] button on the control panel to turn the power OFF. Do not simply press the main power switch to turn the power
OFF, otherwise the stored data may be lost or the hard disk may be damaged.
If a job in process exists when the [POWER] button of the control panel is pressed, “ Processing job will be deleted Are you sure you
want to shutdown ?” appears. If you press [YES], the job in process will be deleted and the equipment will be shut down. If you do not
want to shut down the equipment, press [NO]. •
•
Press the [POWER] button until the sound is heard. “Shutdown in progress” appears on the menu. After a while,
the power of the equipment is turned OFF.
If you will not use the equipment for a long period of time, press the [POWER] button on the control panel to shut down
the equipment, confirm that the ON/OFF lamp is not lit and then turn the power OFF with the main power switch.
When the power is turned OFF with the main
power switch, the main power switch lamp will go
out.