Toshiba e-STUDIO 2020c, Быстрый старт

Страница: 16 / 78

Chapter 1 PREPARATIONS
Configuration of options
4 5 6
1 2
11 10
7
9
8
3
1.
Original Cover (KA-3511PC)
This is used to hold an original.
2.
Reversing Automatic Document Feeder (MR-3018)
This unit automatically feeds a stack of originals one by
one to have them copied.
3.
Bridge Unit (KN-4520)
This unit acts as a relay for the Finisher and this
equipment.
4.
Paper Feed Pedestal (KD-1023)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-032).
5.
Large Capacity Feeder (KD-1024)
This feeder enables you to feed up to 2500 sheets (80 g/m
2
or 20 lb. Bond) or 2000 sheets (90 g/m
2
or 28 lb. Bond) of
A or LT paper.
6.
Additional Drawer Module (MY-1032)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-023). Combined with the 2 drawers in the
equipment, paper can be fed from drawers in total.
7.
Finisher (MJ-1101)
This Finisher enables sort/group finishing and stapling.
The Hole Punch Unit (optional, MJ-60) can be installed
in this Finisher. The Bridge Unit (optional, KN-520) is
required for the installation of this Finisher.
8.
Saddle Stitch Finisher (MJ-1030)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(optional, MJ-600) can be installed in this Finisher. The
Bridge Unit (optional, KN-520) is required for the
installation of this Finisher.
9.
Hanging Finisher (MJ-1031)
This Finisher enables sort/group finishing and stapling.
The Bridge Unit (optional, KN-520) is required for the
installation of this Finisher.
10.
Hole Punch Unit (MJ-6101)
This unit enables you to punch holes on printed sheets.
Install it in the Finisher (optional, MJ-0) to use it.
11.
Hole Punch Unit (MJ-6004)
This unit enables you to punch holes on printed sheets.
Install it in the Finisher (optional, MJ-030) to use it.