- 8 -
Upside
P
5.
INSTALLATION
Note: The attached screws are used to install the camera to a solid surface. If installing to surfaces
of loose or thin materials, use the appropriate anchors (not included) with the screws.
5-1. Installing the Camera
5-1-1. Tamper Resistant Feature
1. To remove the cover, rotate the
cover counter clockwise.
Pull on the cover to remove it from
the base.
2. Move "Lock Pin" with a screwdriver
from "Unlock" position to "Lock"
position.
3. Align the "Unlock-button" with
position "P". (Refer to the left
figure.)
4. Rotate the cover clockwise to lock
the cover to the base.
Enabling the Tamper Resistant Feature
To remove the cover.
1. Unlock the cover by pressing the
"Unlock-button" with a screwdriver.
2. While the "Unlock-button" is
depressed rotate the cover
counter clockwise.
3. Pull on the cover to remove it from
the base.
Cover Removal with the Tamper Resistant Feature Enabled
Caution: Pulling on the cover with excessive force can cause the inner connector to break.
Unlock-button
Base
Cover
Unlock-button
Cover
Screwdriver
Lock Pin
Downloaded from
www.Manualslib.com
manuals search engine
