Toshiba 1600XPi SERIES, Инструкция по установке и эксплуатации

Страница: 38 / 140

28 1600XPi Series UPS Installation and Operation Manual – 60616-014
12.3 Status Indicators
The four top and three bottom UPS status Indicators on the main screen and their meanings are listed in the table below.
Indicator Functional Description
96% Shows the current load percentage.
100% / 11’
100% / 9’ 35”
100% / N/A
Battery Information: In On-Line and Battery Back-up mode the display alternates between
battery charge percentage and estimated remaining battery runtime in:
Format
xx M – Minutes for Runtimes > 10 min.
xx M.xx S – Minutes and Seconds for Runtimes < 10 min.
In other modes, the display alternates between battery charge percentage and “N/A.”
INV
Shows current UPS Status. Indicator will change as the UPS status changes. For a
detailed listing see page 57 .
12:35 PM System Time
DVCOH Fault Description Code – For a detailed listing see page 57 .
ASYN Warning Description Code – For a detailed listing see page 58 .
On-Line Current Operating Mode of the UPS – For a detailed listing see page 60.
12.4 Light Emitting Diodes (LED)
The following table describes the front panel LED behaviors and the associated meaning.
LED Behavior Significance/Meaning
Green - ON UPS is in On-Line, Backup, or Battery Test mode.
Green - OFF UPS in Bypass mode.
Green - OFF Load Discharging
Red - ON One or more faults occurred. See
Records: Faults
for details.
Red - Flashing Charger overvoltage occurred.
Red - OFF No fault occurred.
Amber - ON
Service Call needed, Less than 6 mo. of Battery Life or Battery Life
End .
Amber - Flashing One or more Warnings occurred. See
Records: Warnings
for details.
Amber - OFF No Warning (Normal, UPS in operation).
Green - ON Input voltage is within specified range.
Green - Flashing Input voltage is over specified range.
Green - OFF Input voltage is under specified range.
NOTE: On-Line/Fault LEDs - Appear Amber if Green and Red flash concurrently.
AC Input
Warning
On-Line/
Fault