TOSHIBA TEC Corporation B-FP Series, Руководство пользователя, Страница: 73 / 124

-67-
(2) Manual Selection ({.|.})
The control code of the command is {(7BH),|(7CH),}(7DH), and the control code selection is not performed.
Data of 00H to 1FH is ignored and discarded of in this mode. However, data of 00H to 1FH becomes valid
while processing the Graphic command or Writable Character command in hexadecimal mode.
{.|.} cannot be used in the data of the Data command or Display command.
(3) Manual Selection (ESC.LF.NUL)
The control code of the command is [ESC](1BH),[LF](0AH),[NUL](00H), and the control code selection is not
performed.
Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL C Mode ESC/POS Z Mode
o x x x
7.4.6 EURO Font Code Setting (EURO Code)
This setting determines to which code the EURO font code is to be assigned.
Max.
value
Min. value Step Display Sign Integer
digit
Decimal
place
0-padding Unit of
measure
0xFF 0x20
1 Hex decimal None 2 0 None h
Default value: B0
Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL C Mode ESC/POS Z Mode
o x x x
7.4.7 MaxiCode Specification Setting (Maxicode Spec)
This setting selects a MaxiCode specification.
・
TYPE1 Compatible with the current version
・
TYPE2 Special specification
Default value: TYPE1
<Supplemental Explanations>
The mode specified by the command in accordance with the status of this parameter is different from the actual
mode. Also, the data transmission method differs partly. For details, refer to the B-FP Series External
Equipment Interface Specification(JEA-03580).
Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL C Mode ESC/POS Z Mode
o o o o