Torqeedo Ultralight 1103 AC, Руководство по эксплуатации

Страница: 25 / 66

Start-up
EN DE
6. Push the control clamping ring (10), the motion link with quick clamp (2) and the
control triangle (1) together.
7. Place the combination of control triangle (10), motion link with quick clamp (2)
and clamping ring (1) in the desired position.
The position of the motion link with quick clamp (2) determines the height
of the motor. The highest point of the propeller must be at least 5 cm below
the surface of the water. The height can also be adjusted at a later time, see
Chapter 6.3, "Setting for optimum depth of water" .
ADVICE
Perform the alignment of the following components, as per "Fig. 57: Com-
bination of clamping ring, motion link and control triangle" :
■
Clamping ring (10)
■
Motion link with quick clamp (2)
■
Control triangle (1)
The swing arm is alongside the propeller. The above components must be
aligned accordingly.
8. Tighten the clamping ring (10) using the already hand-tight tightened M5 screw
(9) to 3.5 Nm (31 lb/in).
ADVICE
The swing arm (6) must be fixed in such a way that it can no longer move
freely.
9. Fix the clamping unit of the control triangle (5) with the quick clamp (4) so that
this fixes the motion link with quick clamp (2) between the clamping ring (10) ax-
ially (3.5 Nm/31 lb/in).
6.2.3 Inserting the motion link in the bracket
1
2
3
Fig. 58: Motion link fitted
1 Bracket with trim mechanism 3 Motion link
2 Quick clamp
1. Insert the motion link (3) through the quick clamp (2) into the bracket (1).
2. Close the quick clamp (2).
3. Check that the combination is fitted correctly.
page 89 / 128