Torqeedo Cruise 2.0 FP, Руководство по эксплуатации

Страница: 85 / 96

85
Deutsch
English
7.2 Changing the propeller
1. Turn the battery master switch to the “OFF” position or neutral position.
2. Loosen the shaft anode (for disassembly it is best to use a 17 mm 12-point long
reach socket). Remove the O-ring seal by loosening the underlying nut. This makes it
simpler to slide the O-ring seal off the shaft (again, use a 17 mm 12-point long reach
socket for this purpose).
3. Pull the propeller off the shaft together with the washer.
4. Pull the shear pin out of the motor shaft, remove the ring or washers.
5. Turn the battery master switch to the “ON” position. Let the motor run at slow speed
and check the shaft sealing ring for smooth shaft operation. In case of a damaged or
unbalanced shaft please contact Torqeedo’s Service Dept.
6. Turn the battery master switch to the “OFF” position or neutral position. Mount the
ring, then insert the shear pin.
7. Slide the propeller onto the shaft all the way to the stop, then rotate the groove in the
propeller until it is in line with the shear pin.
8. Slide the washer over the shaft and tighten the hexagon locknut to the propeller (11
Nm).
9. Refasten the O-ring seal.
10. Helpful hints for items 8 and 9: If necessary, use an auxiliary tool such as a centre
punch, a tapered punch or a mandrel on which to slide the disk, the nut, and finally
the O-ring seal.
11. Refasten the shaft anode (7.5 Nm).
Nut
Terminal connectors
Propeller
Shaft anode
O-Ring