Torqeedo Cruise 2.0 FP, Руководство по эксплуатации

Страница: 83 / 96

83
Deutsch
English
5.4 Pylon
The motor and the electronic control system are located in the pylon. They generate the
propulsion. In addition, several protective functions are integrated:
1. Temperature protection: If the motor overheats, the motor control system reduces the
output of the drive until a temperature equilibrium is established between generated
and disposed heat. If a critical temperature was exceeded, the motor will come to a
stop and the error code E02, E08, or E46 will be shown in the display.
2. Under-voltage protection: If the voltage falls below 18 V for Cruise 2.0 models or 36 V
for Cruise 4.0 models (or under 21 V / 42 V if the motor is run with lithium batteries),
the electronic controller switches the drive off to prevent over-discharging the batte-
ries. The display shows error code E43.
3. Blocking protection: If the propeller is blocked or stuck, the motor would nor-
mally take in too much power. In this case, the motor is switched off within a few
hundredths of a second to protect the electronics, motor winding and propeller. After
removing the blockage you can switch the motor on again. If there is a blockage the
display shows error code E05.
4. Cable break protection: In case of damage to one of the connecting cables, i.e. in case
of an interrupted connection to the remote control, the motor will either not start at all
or will come to a stop. The error code E30 / E32 will appear in the display.
5. Throttle control: The speed at which the propeller adjusts to a changed throttle posi-
tion is limited in order to protect mechanical drive parts and to avoid short-term peak
current.
• In case of motor malfunctions, an error code will pop up on display.
After resolving the malfunction, make sure throttle is in neutral
position then return to normal operation. Please refer to chapter 5.3.4.
for any description and details.
• Only run the motor when propeller is under water. If the motor is
operated outside of the water for more than a few minutes, the shaft
sealant rings that seal the motor to the drive shaft may be damaged
and the motor itself may overheat.