Torqeedo Cruise 2.0 FP, Руководство по эксплуатации

Страница: 62 / 96

62
Deutsch
English
4.2 Electronics box installation
Open the cover of the electronics box.
To do this, you must remove the screws as shown
in the drawing.
Loosen the large plastic nut on the side of the electronics box if
necessary and insert cables. Connect the two power cables to
the appropriately marked poles (red=+, black=-; 5 Nm) in the
electronics box. Connect the data cables, then secure
the cables through the box by securely tightening the
large plastic nut. This compresses the seal and makes
the connection waterproof.
The bending radius of the cable cannot be less than 85 mm (3.5 in) to avoid damage to
the cable. Ensure that cable and electronics box are connected waterproof.
Screw the cover back on.
Ideal installation situation:
Fasten the electronics box to the hull or bulkhead so
that the cooling fins are vertical.
4.3 Connecting the GPS sensors
Attach the cable of the GPS sensor directly to the electronics box.
For optimal reception, ensure the sensor is not covered, especially by metal.
Connection
for remote
throttle
control
Connection
for GPS
sensor