Torqeedo Cruise 2.0 FP, Руководство по эксплуатации

Страница: 61 / 96

61
Deutsch
English
4. Installation
4.1 Motor installation
We recommend that the Cruise FP
is installed by a certified boat builder
or other trained professional installer.
To mount the pod drill three holes in the
appropriate hull location as illustrated.
The two small holes are 11 mm (0.4 in) in diameter,
while the large hole in the middle is 43 mm (1.7 in) in diameter.
Remove the two M8 bolts to separate mounting assembly
(adapter block and mounting flange) from the lower motor unit.
If necessary, remove the adapter block and trim to match the hull.
Slide the adapter block on to the mounting flange
with the trimmed side facing up.
Apply marine-grade sealant to the entire mounting
surface of the adapter block. Make sure to completely seal the
area where the pipe of the mounting flange comes through the
adapter block.
Slide the cables and large pipe of the motor assembly into the
large hole and the two threaded bolts into the small holes
drilled in the hull. Use the provided M10 lock nuts and washers
to securely fasten the motor assembly from the inside of the hull. Insert motor and cable
through the mounting assembly and hull. Secure lower motor unit by fastening the shaft
clamp to the mounting flange with the two M8 bolts removed previously.
Depending on hull construction, a reinforcing base
plate may be necessary between hull and washers/lock nuts.
Please mount the propeller as described in chapter 7.2 .
• Danger of falling components or motor itself. Moderate or severe
physical injuries may result.
• Motor components may be broken due to transport. Check all
components before and after mounting to prevent the mounting of
broken components. Malfunctions could result in high temperatures
of motor or electronics.
Ø 11 mm
Ø 43 mm
Ø 11 mm
mm (3.7 in)
mm (7.8 in)
mm (3.5 in)
mm
(1.9 in)
(0.4 in) (0.4 in)
(1.7 in)