Startup
3. Tighten the two transom clamp bolts (1).
4. Additionally, attach the drive using four M12 mounting screws, by screwing the
drive to the boat's transom through the drilled holes for the clamping jaws (2) of
the transom bracket.
10-30 mm
(0.4-1.2 in.)
Fig. 37:
Installation position
When attaching the motor to the boat, ensure that the propeller is mounted at least
10 to 30 mm below the boat hull.
Make sure that the transom bracket is entirely above the waterline.
5.2 Installation of propeller and fin
Installation of fin
WARNING!
Danger of injury from propeller!
Moderate or severe physical injuries may result.
■
When working on the propeller, always switch the system off at the main
switch.
■
Pull out the Emergency Stop magnetic chip.
2
1
Fig. 38:
Fin attachment
1
Fin
2
Aluminium bolts
page 75 / 113
