Toro Z Master Commercial TURBO FORCE 3000 Series, Руководство оператора

Страница: 63 / 72

g006530
Figure 96
1. Cutting edge 3. Wear/slot forming
2. Curved area 4. Crack
Checking for Bent Blades
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Rotate the blades until the ends face forward
and backward.
4. Measure from a level surface to the cutting
edge, position
A , of the blades ( Figure 97 ).
g000975
Figure 97
1. Measure here from blade
to hard surface 2. Position A
5. Rotate the opposite ends of the blades forward.
6. Measure from a level surface to the cutting edge
of the blades at the same position as in step
4
above.
Note:
The difference between the dimensions
obtained in steps 4 and 6 must not exceed 3
mm (1/8 inch).
Note:
If this dimension exceeds 3 mm (1/8
inch), the blade is bent and must be replaced.
WARNING
A blade that is bent or damaged could
break apart and could seriously injure or
kill you or bystanders.
• Always replace a bent or damaged
blade with a new blade.
• Do not file or create sharp notches in
the edges or surfaces of the blade.
63