Toro Z Master Commercial TURBO FORCE 3000 Series, Руководство оператора

Страница: 62 / 72

least 1/3 the length of the available travel in
their slots. This will regain some up-and-down
adjustment on each of the 4 deck links.
g017036
Figure 95
1. Single-point-adjustment bolt
14. Torque the 2 bolts at the bottom of the
height-of-cut plate (
Figure 94 ) to 37 to 45 N∙m
(27 to 33 ft-lb).
Note:
For most conditions, adjust the back
blade tip 6.4 mm (1/4 inch) higher than the front.
15. On both sides of the deck, measure from the
level surface to the back tip of the blade (Postion
B). The measurement should read 8.3 cm (3-1/4
inches); refer to
Figure 92 .
16. Fine-tune the adjuster screw by turning it to get
8.3 mm (3–1/4 inches) height (
Figure 93 ).
To increase the height, turn the adjustment nut
clockwise; to decrease the height, turn the nut
counterclockwise.
17. Measure until all 4 sides are the correct height.
Tighten all the jam nuts on the deck-lift arm
assemblies.
18. Lower the discharge chute.
Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
you may want to keep extra blades on hand.
Blade Safety
A worn or damaged blade can break, and a piece of
the blade could be thrown toward you or bystanders,
resulting in serious personal injury or death. Trying to
repair a damaged blade may result in discontinued
safety certification of the product.
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating 1
blade can cause other blades to rotate.
Before Inspecting or Servicing the
Blades
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges ( Figure 96 ).
2. If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
Sharpening the
Blades (page 64) .
3. Inspect the blades, especially in the curved area.
4. If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(
Figure 96 ).
62