Toro Z Master Commercial TURBO FORCE 3000 Series, Руководство оператора

Страница: 27 / 72

Adjusting the Height of Cut
Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
OCK
position and a
U
NLOCK
position for the transport position ( Figure 30 ).
g032377
Figure 30
Transport-Lock Positions
1. Transport lock 3. U
NLOCK
position—does
not lock the mower deck
into transport position
2. L
OCK
position—mower
deck locks into transport
position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
Figure 31 .
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket (
Figure
31 ).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (
Figure 31 ).
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
g029636
Figure 31
1. Deck-lift pedal 3. Transport lock
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
32 , Figure 33 , and Figure 34 .
27