Toro Z Master 74901, Руководство по обслуживанию

Страница: 165 / 188

MOWER DECKS
6-28 Toro Z Master G3 3000/5000/6000 Series Service Manual
6
Inspecting the Blades Checking for Bent Blades
2. Inspect the blades, especially the curved area (Fig.
098). If you notice any damage, wear, or a slot
forming in this area (Fig. 463), immediately install a
new blade.
A. Cutting edge C. Wear/slot forming
B. Curved Area D. Crack
1. Measure here from 2. Position A
blade to hard surface
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Rotate the blades until the ends face forward and
backward (Fig. 464). Measure from a level surface to
the cutting edge, position A, of the blades (Fig. 464).
Note this dimension.
Fig. 463 fig. 98 G006530
Fig. 464 fig. 99 G000975
Service Interval: Before each use or daily
1. Inspect the cutting edges (Fig. 463).
Note: If the edges are not sharp or have nicks,
remove and sharpen the blades. Refer to
“Sharpening the Blades” on page 6-30.
A
B
C
D
2
1