Toro Z Master 4000 Series, Руководство по обслуживанию, Страница: 57 / 114

Choke Cable Assembly Engine Removal
Note the position of the throttle clamp on the engine plate.
1. Remove the cable clamp screw securing the cable to the engine plate.
Remove the clamp from the engine plate.
2. Disconnect the choke cable.
3. Feed the cable through the retainers and out of the pod.
Choke Cable Assembly Engine Installation
1. Feed the cable through the retainers.
2. Connect the choke cable.
3. Install the clamp to the engine plate. Install the cable clamp screw securing
the cable to the engine plate.
Choke Cable Assembly Unit Installation
1. Connect the choke cable.
2. Install the nut to the bottom side of the choke cable securing the cable to
the pod.
3. Install the RH side pod to the RH console. Install the 4 (1/4-20 inch) torx
screws securing the RH side pod to the RH console.
g346220
Figure 33
4. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Seat Replacement
Seat Removal
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 2 (5/16 inch) torx screws securing the rear of the seat pan to
the chassis.
4000 Series Z MASTER® Service Manual Page 5–17 Chassis: Service and Repairs
3442-427 Rev A