Toro Z Master 4000 Series, Руководство по обслуживанию, Страница: 55 / 114

Throttle Cable Assembly Replacement
Throttle Cable Assembly Unit Removal
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 4 (1/4-20 inch) torx screws securing the RH side pod to the RH
console. Remove the RH side pod from the RH console.
Note: In image below, 3 screws are shown.
g346220
Figure 30
4. Unscrew the throttle control knob from the throttle control.
5. From the bottom side of the throttle control, remove the 2 (10-24 inch) lock
nuts securing the throttle control to the RH console.
6. Disconnect the throttle cable.
Throttle Cable Assembly Engine Removal
Note the position of the throttle clamp on the engine plate.
1. Remove the cable clamp screw securing the cable to the engine plate.
Remove the clamp from the engine plate.
2. Disconnect the throttle cable.
Throttle Cable Assembly Engine Installation
1. Connect the throttle cable.
2. Install the clamp to the engine plate. Install the cable clamp screw securing
the cable to the engine plate.
Throttle Cable Assembly Unit Installation
1. Connect the throttle cable.
2. From the bottom side of the throttle control, install the 2 (10-24 inch) lock
nuts securing the throttle control to the RH console.
3. Screw the throttle control knob to the throttle control.
4. Install the RH side pod to the RH console. Install the 4 (1/4-20 inch) torx
screws securing the RH side pod to the RH console.
4000 Series Z MASTER® Service Manual Page 5–15 Chassis: Service and Repairs
3442-427 Rev A