g203963
Figure 67
1.
Tension nut
2.
Tension screw
16.
Align the closest notch in the tension screw to
the locking bolt hole and secure the screw with
the locking bolt and nut.
17.
Torque the rear bolt to 108 to 122 N∙m (80 to
90 ft-lb).
18.
Lower the machine to the ground.
19.
Repeat the procedure to replace the other track.
20.
Drive the machine, then park the machine on a
level surface, engage the parking brake, shut off
the engine, and remove the key.
21.
Verify that the tension block is bottomed out.
Note:
The track tension loosens after some
use.
22.
Adjust the track tension so that the tension block
aligns with the green guide on the decal or is 1.3
cm (1/2 inch) away from the rear of the tension
tube slot; refer to
(page 39)
.
Cooling System
Maintenance
Cooling System Safety
•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Servicing the Cooling
System
Service Interval:
Before each use or daily—Clean
the screen, oil cooler, and front of
the radiator (more often in dirty or
dusty conditions).
Before each use or daily—Check the coolant
level in the expansion tank.
Every 100 hours—Check the cooling system
hoses.
Yearly—Change the engine coolant (Authorized
Service Dealer only).
Cleaning the Radiator Screen
Service Interval:
Before each use or daily
Remove any buildup of grass, dirt or other debris from
the radiator screen with compressed air.
Checking the Engine-Coolant
Level
The cooling system is filled with a 50/50 solution of
water and permanent ethylene-glycol antifreeze.
1.
Park the machine on a level surface, lower the
loader arms, engage the parking brake, and
shut off the engine.
2.
Remove the key from the key switch and allow
the engine to cool.
3.
Check the coolant level in the expansion tank
(
).
The coolant level should be at or above the mark
on the side of the tank.
43
Содержание TX 1000 Compact Tool Carrier
