Toro TITAN, Руководство по обслуживанию

Страница: 32 / 121

Engine Removal (continued)
g349637
Figure 8
12. Disconnect the throttle cable. Throttle Cable Assembly Removal (page 5–26)
13. Disconnect the choke cable. Choke Control Assembly Removal (page 5–29)
14. Disconnect the clutch wire from the clutch.
15. Remove the (7/16 x 3 inch) clutch mounting screw and 2 washers. Slip the
clutch off of the crankshaft.
Note: Before removing the clutch, note the orientation of the clutch wire
and the clutch.
16. Remove the engine pulley. Retain the square key securing the pulley to
the crankshaft.
17. Remove the 4 (0.375-16 x 1.500 inch) engine mounting screws.
Note: Before removing the engine mounting screws, note the orientation of
the clutch anchor. The clutch wire can remain attached to the clutch anchor.
18. Remove the engine from the frame.
Engine Installation
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Install the engine onto the frame.
3. Align the 4 holes of the engine base to the frame and attach the 2 (0.375-16
x 1.500 inch) rear mounting screws and belleville washers loosely.
4. Attach the front 2 screws and belleville washers through the clutch anchor
and into the engine base.
5. Torque the 4 screws to 36.6–44.7 N • m (27–33 ft-lb).
6. Install the key and engine pulley onto the crankshaft.
Note: Install the engine pulley with the larger diameter hub toward the engine.
7. Install the clutch onto the crankshaft ensuring that the slot in the clutch aligns
with the tab on the clutch anchor.
8. Install the 2 spring washers and the (7/16 x 3 inch) clutch screw. Torque the
screw to 66.4–82.7 N • m (49-61 ft-lb).
Engine: Service and Repairs Page 4–6 TITAN® Max Service Manual
3442-428 Rev A